How to choose a silicone mold for the washbasin?

How to choose a silicone mold for the washbasin?

Key selection criteria
Material selection: Choose food-grade platinum silicone (additionally formed silicone). This material is resistant to alkali and corrosion, while the pH value of cement is very high. Poor-quality silicone will become sticky and brittle after being soaked a few times.


Wall thickness and hardness: The recommended wall thickness is between 1.5cm and 3cm. If it is too thin, it cannot support the weight of the cement and is prone to collapse and deformation when filled; if it is too hard, it is difficult to remove from the mold. The hardness should be around 10 to 15 degrees, which is soft and hard enough with strong elasticity.


Inner wall smoothness: The smoother the inner wall of the mold, the finer the surface of the washbasin made will be, and the amount of subsequent polishing work will be greatly reduced.
Detail design: Prefer molds with bottom micro-slope design, so that water can flow naturally to the drainage hole without the need to later carve the slope; the edges should preferably have double-layer reinforcement treatment to prevent expansion and deformation during mold removal.


Common DIY materials and techniques
Cement/Concrete: The most mainstream approach. Mix cement, fine sand, short-cut glass fibers, and plasticizing additives, and pour it into the silicone mold. After curing and removing from the mold, use sandpaper to polish and apply waterproof protection paint or epoxy resin to create a handcrafted or minimalist washbasin with an industrial or Zen vibe.


Resin/Epoxy Resin: Suitable for making transparent, ink-wash patterns, or adding dried flowers, gold leaf, etc. for decoration. Resin has good fluidity and requires extremely high gloss requirements for the mold.
Gypsum: Suitable for creating lightweight, matte-surfaced decorative washbasins or mini water basins. However, its waterproof performance is relatively poor, and it usually needs to be combined with a large amount of waterproof coating.


Usage and mold removal troubleshooting guide
Apply mold release agent: Apply a thin layer of edible oil, vaseline, or a dedicated mold release agent on the inner side of the silicone mold. This ensures easy mold removal after curing and prevents damage to the mold or cracks in the finished product.


Exhaust air bubbles: When filling cement slurry or resin, fill it in in several stages and gently tap the sides of the mold to remove internal air. Inclusions of air not only cause air bubble defects but also reduce the final strength of the finished product.


Let it stand and cure: Do not rush to remove the mold. The initial curing time of cement formulations usually requires at least 24 hours, and after removal, it needs to stand for 48 hours to become stable and hard.
Post-curing care: After removing the mold, the surface of the cement basin will have tiny pores. It is recommended to use acrylic putty to level it, polish it smooth, and then apply a layer of waterproof sealant, followed by a second layer of epoxy resin. This provides both waterproof and stain-resistant properties.

 

Back to blog

Leave a comment

1 of 3